Curt Manufacturing's # 56008 Acura RDX Trailer Wiring Kit T-Connector Harnesses are designed to make connecting your trailers wiring a snap. No need to cut or modify your vehicles existing wiring harness, Curt's custom fit T-connector trailer wiring kits will plug right into your existings factory wiring. On most vehicles this simple design only requires you to unplug your stock harness at its connection point (usually located near your taillights) and then plug in the new Curt Acura RDX wiring kit. This requires no cutting or no soldering of any of the wires. Built-in converters are pre-wired into applications that require taillight conversion. Once installed this Curt 56008 kit will provide a standard 4 wire flat connection you connect you Acura RDX to your trailer.
Features and Benefits
Simple Plug and Go design
Curt 56008 is designed specifically for the Acura RDX
Provides a standard 4-wire flat connection for a vehicle to trailer connection
No cutting or splicing of the factory wiring system
Note the line at top of instructions. A fuse needs to be installed in fuse box under car hood for the rear port to be hot. Really should be first line of installation instructions "Be sure fuse is installed in Acura fuse box." Fortunately, Acura includes spare fuses but leaves the slot for the rear plug empty. Would have been nice to include a fuse with kit. Otherwise, it takes 5 minutes to install. If the fuse for rear port is not in, no reason to unhook the battery. The rear port for the plug is a little more hidden than instruction picture implies.