Curt Manufacturing's # 55540 Chevy Express Trailer Wiring Kit T-Connector Harnesses are designed to make connecting your trailers wiring a snap. No need to cut or modify your vehicles existing wiring harness, Curt's custom fit T-connector trailer wiring kits will plug right into your existings factory wiring. On most vehicles this simple design only requires you to unplug your stock harness at its connection point (usually located near your taillights) and then plug in the new Curt Chevy Express wiring kit. This requires no cutting or no soldering of any of the wires. Built-in converters are pre-wired into applications that require taillight conversion. Once installed this Curt 55540 kit will provide a standard 4 wire flat connection you connect you Chevy Express to your trailer.
Features and Benefits
Simple Plug and Go design
Curt 55540 is designed specifically for the Chevy Express
Provides a standard 4-wire flat connection for a vehicle to trailer connection
No cutting or splicing of the factory wiring system
I would recommend a dozen or so extra tie wraps across the top of the rear doors to secure the new wire. Wrap and add protection to the length of wire with the trailer connector on the outside of the van with a roll of electrical tape. I store the outside length of wire with the connector inside my van. The rear door seals prevent damage to the wire when I close the doors while I'm using my trailer.