Curt Manufacturing's # 56163 Kia Sorento Trailer Wiring Kit T-Connector Harnesses are designed to make connecting your trailers wiring a snap. No need to cut or modify your vehicles existing wiring harness, Curt's custom fit T-connector trailer wiring kits will plug right into your existings factory wiring. On most vehicles this simple design only requires you to unplug your stock harness at its connection point (usually located near your taillights) and then plug in the new Curt Kia Sorento wiring kit. This requires no cutting or no soldering of any of the wires. Built-in converters are pre-wired into applications that require taillight conversion. Once installed this Curt 56163 kit will provide a standard 4 wire flat connection you connect you Kia Sorento to your trailer.
Features and Benefits
- Simple Plug and Go design
- Curt 56163 is designed specifically for the Kia Sorento
- Provides a stand 4-wire flate connection for a vehicle to trailer connection
- No cutting or splicing of the factory wiring system
4 cylinder models only
Part 56163 fits:
- 2013 Kia Sorento (4 cylinder models only)
- 2012 Kia Sorento (4 cylinder models only)
- 2011 Kia Sorento (4 cylinder models only)
All connectors worked perfectly. The wires were too short, which made for a complicated blind instillation. If the wires were 16' to 20" inches longer, on the drivers side, instillation would have been easy.
The instructions failed to tell you how to route the wiring harness. I called and got much better instructions. Routing the wire from the battery to the wiring harness takes a lot of time and patience. On a scale of 1 to 10, 10 best, I rate the product 7.5, do to short wires and poor written instructions.
Recommend this Product: