Curt Manufacturing's # 56013 Chevy Malibu Trailer Wiring Kit T-Connector Harnesses are designed to make connecting your trailers wiring a snap. No need to cut or modify your vehicles existing wiring harness, Curt's custom fit T-connector trailer wiring kits will plug right into your existings factory wiring. On most vehicles this simple design only requires you to unplug your stock harness at its connection point (usually located near your taillights) and then plug in the new Curt Chevy Malibu wiring kit. This requires no cutting or no soldering of any of the wires. Built-in converters are pre-wired into applications that require taillight conversion. Once installed this Curt 56013 kit will provide a standard 4 wire flat connection you connect you Chevy Malibu to your trailer.

Features and Benefits

  • Simple Plug and Go design
  • Curt 56013 is designed specifically for the Chevy Malibu
  • Provides a stand 4-wire flate connection for a vehicle to trailer connection
  • No cutting or splicing of the factory wiring system
Install Time: 20 minutes minutes
Download Instructions: 56013 Instructions
Weight: 3 lbs.
Part 56013 fits:
  • 2007 Chevy Malibu
  • 2006 Chevy Malibu
  • 2005 Chevy Malibu
  • 2004 Chevy Malibu
  • 5.0 out of 1 Overall
  • 100% reviews recommend this product
Review Product
direct fit
Direct fit. However the wires to the trailer are quite long, so I had to zip tie the wires after I folded to have the length so they were not dragging the ground.
Recommend this Product: YES
LeeRoy
2007 Malibu LS
– Value
– Quality
– Installation
"